Madera Marinefishing rod storage system
Contact Madera Marine
Phone: 727.398.7600
Fax: 727.398.1707

E-mail: sales@maderamarine.com

........................................................
........................................................

Choose Your Rod Carrier

Quad Rodz
Tri Rodz
Bi Rodz

Made in the USA!!!
gif_flagd_9

........................................................

Links and Resources

Transport multiple fishing rods and reelsfishing rod carrier

Instructions for use

Untitled-4
Just snap each rod into place......
Rod Carrier
then wrap to secure.
  1. First take notice of the two ends of the rod carrier. One end is marked TOP and the other end is marked BOT (bottom). They ARE different sizes and designed to match the average taper of the rod. It is essential that the ends be placed appropriately on the fishing rod to ensure the carrier fits the rod snug.
  2. Hold the carrier in one hand vertically with the BOT (bottom) end closest to the ground.
  3. Undo all Velcro straps allowing them to hang alongside the carrier.
  4. Stand the first rod in an upright position with the butt of the rod sitting on the ground.
  5. Now snap the rod into place on the carrier. The bottom (BOT) end of the carrier should be on the rod blank just above the top of the rod grip.  The (TOP) end should be close to the  lowest eye on the rod (either above or below the eye). Repeat this action with additional rods filling all carrier slots.
  6. Wrap one Velcro strap around the assembly being sure to pull tightly. Fasten Velcro back upon itself to secure rod. Repeat action with other end of carrier.
  7. CONGRATULATIONS! Your multiple rods and reels can now be carried as a single unit.

*To Transport, grip the top rod like you normally would when carrying a single rod


Important

  • Be sure Velcro straps on the carrier are securely fastened before transport.
  • QuadRodz®, TriRodz®, & BiRodz® are to be used only for casual transport of fishing rods and reels. 
  • DO NOT place assembled or partially assembled rod carrier into rod holder of a moving vessel
    or vehicle.
  • Carriers are designed to store and transport fishing rods only (with or w/out reels).
  • Cover or remove all hooks and lures from rods before transporting and storing units to avoid injury.
  • Reinforce the strength of fixed overhead storage to comply with new extra weight requirements.
  • DO NOT balance assembled Rodz system unsupervised close to the water’s edge or any other place where tipping over may cause an issue.  Balance Rodz systems upright at your own risk.
Download Complete Instructions Here (.pdf)